Installation
|
|
|
Weed Control
|
|
|
|
|
|
Step 1
Strip away all existing sod, grasses and weeds in desired area to be landscaped |
Step 2
Unroll fabric and measure to size, allowing enough to go over existing plants to amply reach edging. |
Step 3
Cut X where each plant will be, or cut an X large enough to pull existing plant gently through. |
Step 4
Plant your plant or pull Fabriscape's over existing plant, be gentle with branches and gently tuck the corners of fabric around plant stem. |
Step 5
Generously arrange decorative stone or bark around plants to ensure protection of Fabriscape's from sunlight. |
Patio / Paver Underliner
|
|
|
|
|
|
Step 1
Excavate area to desired depth to accommodate stone, sand and brick. |
Step 2
Fill area with crushed stone and compact with vibrator. |
Step 3
Place Fabriscape's Patio/Paver Underliner over crushed stone base. |
Step 4
Spread a 2" layer of course sand over the fabric and level in preparation for setting brick in place. |
Step 5
Place bricks in desired pattern and spread sand in cracks and vibrate into place. |
Filter Fabric
|
|
|
|
|
|
Step 1
Excavate site and shape to a smooth desired depth. |
Step 2
Place Fabriscape's fabric on surface, leaving room for overlap. |
Step 3
Fill with aggregate and place according to specifications. |
Step 4
Fill remaining site with appropriate aggregate. |
|
Burlapjute
|
|
|
|
|
|
Step 1
Prepare the ground surface either by mechanical means and/or raking to as smooth a surface as possible. |
Step 2
Seed and fertilize the area. |
Step 3
Unroll Burlapjute down slope, without stretching the material. |
Step 4
Anchor the mat by placing pins at 4' and 1' staggered intervals in adjacent panel overlap area. |
Step 5
Overlap the end of each roll and adjacent panel sides at least 4". Anchor the top, bottom,and any of roll overlaps. |